Management and office offices: For places where there is a lot of open space but there is little space to create offices in the building 2. Types of villas: High resistance to all types of weather as well as easy transportation to a variety of places that are difficult to cross, such as mountainous areas
A prefabricated building refers to a building that is built in the primary environment and assembled in the secondary environment, or is constructed and prepared for this transfer; Prefabricated building materials usually consist of gypsum boards, plastics, wood and light but strong alloys. One of the most important reasons for human tendency to use prefabricated
Buildings that use 3D panels in their construction are among the buildings with prefabricated systems and have special advantages. In buildings with 3D panels, after the panels are transported to the installation site and installed, all the requirements of the joints are installed at all angles and then the concrete spraying process takes place. How
What is the difference between a sandwich panel and a 3d panel? Check the features of sandwich panels and three-dimensional panels Iran is a country with a special geographical location and in addition to the diversity of climates and different climatic conditions is located on one of the active seismic belts in the world. The
How to install the facility Installation and electrical pipes are installed in the distance between the mesh network and the insulation layer. If some of the mesh is cut for installation, the necessary reinforcements should be made around the cut. PVC power cables should not come into contact with EPS (polystyrene). Therefore, they must be
This product is mostly used in high-rise buildings, because in the design and construction of such buildings, a reasonable reduction in the weight of materials (dead load) is considered, which can be achieved by using this product, because the weight of one square meter of brick wall 22 cm with cement sand mortar and lined
3d barber panel applications: Panels with polystyrene core and reinforced concrete (steel mesh and high-strength sprayed concrete) are used for the following: - Barber wall - ceiling - Non-load-bearing partition walls (interior and exterior) - Structural structures including shear walls, roof panels and insulation walls against heat and sound transmission are used. Advantages and disadvantages:
Three-dimensional panel components (sandwich panel) Cutter Cold drawn wire Mesh network spring (dimensions of mesh network spring are 50 to 80 mm). Welded mesh (diameter of welded mesh wires is from 2.5 to 6 mm). Technical specifications of 3D Panel style light walls Cutter: The steel truss member is connected to the two layers of
3D panel is a prefabricated wall made of two parts of refractory polystyrene insulation core (Ionolite) and Steel mesh (mesh) is formed by trussing metal wires to They are connected to each other by installing and spraying concrete on it by combining two steel and concrete nets, the structure is very It is obtained strong
One of these types of prefabricated systems is 3D panel, which is made of a layer of polystyrene or the same Refractory ionolite is formed in the middle and two wire mesh networks on its two sides. After placement Prefabricated panels in place, shotcrete (concrete spraying) is done. The goodness of this bridge Starin (ionolite)
